PMDG problem with FsP

[aristoteles]

Sorry if this has been asked before:
Regarding the V speeds for the PMDG 737: When loading passengers and cargo, Fsp gives me the ZFW but , when I enter the data on the FMC, it doesn´t
give me the V1, Vr and V2
since they are not the same as the ones given to me by the loadeditor from PMDG , how do you guys do it?
Thanks in advance.

[runibl]

On the PMDG 737, you don't have to manually input Performance data. Just click on the LSK button for "GW/CRZ CG" and "ZFW" Then you input a number in
"Reserves" I usually out in 1. Then input a number for "Cost index" I usually input 100 which gives me a nice cruise speed. Then input altitude in
"TRIP/CRZ ALT". When filled right it should show "N1 LIMIT>" in 6R LSK which you press to get to next page.

On the "N1 LIMIT" page, you choose the takeoff and climb performance. I usually just use the top one for both "<TO" and "CLB" for max performance
(this also uses the most fuel. After you have chosen what you want, select "TAKEOFF>" in 6R LSK.

On the "TAKEOFF REF" page, you need to choose a flap setting. I use "5" for flaps, which is I think a normal setting. Then you need to press "1R LSK",
"2R LSK" and "3R LSK" to get the V1, Vr and V2 speeds. When done it should say "PRE-FLT COMPLETE" across the center of the screen. If it doesn't show,
then you have forgotten something. Make sure that you have a valid route and a runway selected for takeoff.

I usually start loading pax on to the aircraft right before setting the FMC.

[aristoteles]

Thanks a lot for those tips, runibl, very helpful...

[Drew]

moved to support now

[runibl]

aristoteles wrote:
Thanks a lot for those tips, runibl, very helpful...

You are welcome. If there is anything else just ask.

Btw, most of this is in the manual.