![]() |
PMDG problem with FsP - Printable Version +- FsPassengers Forums (http://www.fspassengers.com/forum) +-- Forum: FsPassengers (http://www.fspassengers.com/forum/forumdisplay.php?fid=3) +--- Forum: FsPassengers Support (http://www.fspassengers.com/forum/forumdisplay.php?fid=5) +--- Thread: PMDG problem with FsP (/showthread.php?tid=6002) |
PMDG problem with FsP - aristoteles - 22-02-2006 Sorry if this has been asked before: Regarding the V speeds for the PMDG 737: When loading passengers and cargo, Fsp gives me the ZFW but , when I enter the data on the FMC, it doesn´t give me the V1, Vr and V2 since they are not the same as the ones given to me by the loadeditor from PMDG , how do you guys do it? Thanks in advance. Re: PMDG problem with FsP - runibl - 22-02-2006 On the PMDG 737, you don't have to manually input Performance data. Just click on the LSK button for "GW/CRZ CG" and "ZFW" Then you input a number in "Reserves" I usually out in 1. Then input a number for "Cost index" I usually input 100 which gives me a nice cruise speed. Then input altitude in "TRIP/CRZ ALT". When filled right it should show "N1 LIMIT>" in 6R LSK which you press to get to next page. On the "N1 LIMIT" page, you choose the takeoff and climb performance. I usually just use the top one for both "<TO" and "CLB" for max performance (this also uses the most fuel. After you have chosen what you want, select "TAKEOFF>" in 6R LSK. On the "TAKEOFF REF" page, you need to choose a flap setting. I use "5" for flaps, which is I think a normal setting. Then you need to press "1R LSK", "2R LSK" and "3R LSK" to get the V1, Vr and V2 speeds. When done it should say "PRE-FLT COMPLETE" across the center of the screen. If it doesn't show, then you have forgotten something. Make sure that you have a valid route and a runway selected for takeoff. I usually start loading pax on to the aircraft right before setting the FMC. Re: PMDG problem with FsP - aristoteles - 22-02-2006 Thanks a lot for those tips, runibl, very helpful... ![]() Re: PMDG problem with FsP - Drew - 22-02-2006 moved to support now ![]() Re: PMDG problem with FsP - runibl - 22-02-2006 Quote:aristoteles wrote:You are welcome. If there is anything else just ask. Btw, most of this is in the manual. |