Awwwww. Come on!

[Leftcoaster]

Russ
Could this be a contact point issue from the aircraft.cfg file? I only have one POSKY 767, "Project Opensky - Boeing 767-300ER Air
Canada NOC" but it has three complete sets of contact point data in the aircraft.cfg file, specifically the data in use is titled:

Default with true footprint contact points

with two varients listed as:

Full Motion, Realistic feel, true footprint contact points

and:

3-point, non-realistic feel, non-footprint contact points

both seemingly complete but fully remarked out of the config file.

Although I have very little experiance with this particular model, I seem to recall that it flew and landed just fine back when I actually flew
modern aircraft in FS9. I don't know enough about how FS9 actually uses the Contact Points data to advise on changing the numbers but
if the FDE author produced alternate Contact Points to use, then doing so might provide an effective solution. Maybe a little careful text
editing might solve your problem and get you down intact.

Just thinking out loud, Good Luck.