26-04-2015, 07:23 PM
I'm flying a very long route now so I can't give the exact wording, but this is the general idea. I'm flying the PMDG 772 (FSX Acceleration using FSP2015). I'm also using the generic FSP 772 payload model with the weight & balance, loads, etc. ticked "off".
Everything including fuel and payload is set through PMDG and I simply enter the passengers FSP gives me, add the destination - time enroute, etc.. Passengers are loaded in 20 minutes and all is good. But right after takeoff roll, about the time gear is retracted, FSX pauses and if get a FSP message that I can't change fuel (or something like that) even though I haven't touched the fuel in either FSP or PMDG. I have to work my way out of FSP to continue the flight and so FSP isn't counting the trip.
What's happening, and how to I alleviate the problem?
Thanks!!!!
Everything including fuel and payload is set through PMDG and I simply enter the passengers FSP gives me, add the destination - time enroute, etc.. Passengers are loaded in 20 minutes and all is good. But right after takeoff roll, about the time gear is retracted, FSX pauses and if get a FSP message that I can't change fuel (or something like that) even though I haven't touched the fuel in either FSP or PMDG. I have to work my way out of FSP to continue the flight and so FSP isn't counting the trip.
What's happening, and how to I alleviate the problem?
Thanks!!!!