Lear Jet Lights FSX

[bolz3r]

Hello,

I have a problem to figure out which lights I need to activate in the Lear Jet.

FSP want me to have:
Nav Lights
Beacon Lights
Strobes
Taxi Lights
Landing Lights

I have;
Nav Lights
BCN/Strobe
Recog
L/R Landing/Taxi

When should I activate which light I have in the Lear Jet, to satisfy FSP with full light penalty on?

Another basic question:

When should I activate the Seat Belt lights to satisfy FSP?

Thanks in advance

[whiskey-zulu]

Seatbelts should be on all the time when on the ground, except during re-fueling; PIC's discretion in the air.

Lights wise, you'll have to play around with the settings. I haven't flown the default LearJet for some time, but as a rule, beacon should be on when
the APU and/ or engines are running, as should NAV lights; strobes and landing lights go on when entering the runway after T/O clearance and off when
exiting a runway after landing; landing lights should also be off at 10K feet. Taxi lights on on the ground, off at wheels up.

[bolz3r]

Thanks for the prompt reply!

The problem is, I don´t know what the RECOG light is. Is it compareble to the STROBE on other planes? If I turn it on, nothing happens. Another point
is the combined Taxi/Landing lights. Should I turn them on while taxi, even if the landing lights are on too then?

Please check the link below for better understanding. Thanks a lot!!!

http://www.youtube.com/watch?v=LycuubENrgo

[Joeflyer]

Recognition lights = nav lights. I'm sure you have a switch or button for nav lights?

[bolz3r]

Joeflyer wrote:
Recognition lights = nav lights. I'm sure you have a switch or button for nav lights?

Yes I have the Nav Light Button, but I also have another button called RECOG, which makes nothing.

FSPassenger gave me a penalty for not turning on the strobe light when enter runway. I turned on the BCN/STROBE light right before starting the
engines in Frankfurt and turned it off right after cutoff the engines in Munich. I did that because of the BCN shortcut. I think this means beacon.
Unfortunally it seems like the Strobe light is also on then

In the end it is that I have:

BCN/STROBE = beacon and strobe light together at one switch
NAV = navigation lights
RECOG = this switch doesn´t work
L LDG = all taxi and landing lights together at one switch
R LDG = this switch doesn´t work

How can I use this configuration without getting a light penalty by FSP? Plz help
or how can I make the lights work?



Post Edited ( 01-22-11 16:15 )