01-01-2007, 10:32 PM
I have the CHProducts Yoke and Rudder (USB). Whenever I start taxiing on a Cessna Caravan, the rudder control goes all over the place.
This is a new problem that did not occur before.
To forestall the obvious questions,....
Yes, I recalibrated my pedals, They show as fine and working in the CH Products Control Centre (4.0) and the windows GUI
Yes, I am running Windows XP and FS2004, with Patches
Yes, I have the latest version of FSPax
Yes, I shutdown and restarted FS2004 several times
Yes, I rebooted my machine several times
Yes, I have changed the USB Port it is using
Yes, I am running the latest version of Control Centre
Yes, I have the latest Windows Updates
Yes, I have tried different aircraft
I tested this by creating a flight without FSPassengers and taxiing and taking off fine, then created a FSPax flight, loaded up and it all went
pear-shaped.
Has anyone else had this problem? Has there been a patch for this? Cheers, OzBob
This is a new problem that did not occur before.
To forestall the obvious questions,....
Yes, I recalibrated my pedals, They show as fine and working in the CH Products Control Centre (4.0) and the windows GUI
Yes, I am running Windows XP and FS2004, with Patches
Yes, I have the latest version of FSPax
Yes, I shutdown and restarted FS2004 several times
Yes, I rebooted my machine several times
Yes, I have changed the USB Port it is using
Yes, I am running the latest version of Control Centre
Yes, I have the latest Windows Updates
Yes, I have tried different aircraft
I tested this by creating a flight without FSPassengers and taxiing and taking off fine, then created a FSPax flight, loaded up and it all went
pear-shaped.
Has anyone else had this problem? Has there been a patch for this? Cheers, OzBob