FSX - USA Airports

[Airliner]

Cough ** some a little big* cough

Yeah, sorry about that!

I had already uploaded a few that were done in 1280x1024 before linking over.

I look at redoing them and adding PANC.

I already tried putting BostonV2 into FSX but I got severe flickering textures like you can't imagine!

Side note: I may have finally found a way to link the mouse wheel to act as a trim wheel! I was fiddling with the standard.xml control file
tonight and think I found something I can use. I'll test it out in the morning.

Wow great shots! You must be on a good system to have all that AI, and im guessing to have set your scenery to high as well
seeing as
the airport has ALL its gates insted of like less then half of em. Great shots!

Whoa! Hold on a second. Yeah, I've got a fairly decent system now but, I turned everything up for the images only. I was in slew the
whole time and if I were to fly in some of those larger airport areas, I'd be screwed. Right now, for flying, I leave autogen completely off,
along with road vehicles (the new frame rate killer) and airline traffic dialed back to 75%. That's the tradeoff for having scenery complexity
at maximum - I want details when I'm on the ground - not so important at cruise altitude.

Nice observation too, about the gates. In case anyone didn't notice yet, turning down the complexity removes SOME jetways at each level,
instead of all or nothing.

One other nice thing - no need for afcad file re-working as every single gate is perfectly aligned with it's jetway - just need airline
assignments now.

I also agree on 3rd party stuff. Right now, I'm more than pleased with the defaults - for example, KCLE is just fine for me. KTPA however,
looks a bit too sparse - same with KMCO. However, KDEN - YIKES! Love it!