P3D V 3.3 Is Released

[Joeflyer]

So try it out Sam and report back

I can't as I don't have p3d

Hello All,

Bummer for me actually. Upgraded to P3D 3.3 and turns out that FSP Version is not working with 3.3. Was working perfectly in P3D 3.2. Will just have to wait till its sorted.

Regards

Sam

Sam, would it be too much trouble for you to go back to 3.2? Again, I don't know when Dan will decide to show up with an update.
By the way, is 3.3 much better than 3.2?? I'm staying with 3.2 for a while. It performs quite well...and, FsP works