Wilco E-jets Series and FspX

[vakantieman]

All,

I recently bought this superb add-on for FSX. The first plane I bought in my own airline company is the Embraer 190 House colors from
the Wilco E-jets add-on. I started a flight in FSX, set the load manager to full fuel and full load. Created a flight plan from EHAM(schiphol)
to EDDF(Frankfurt) normal flight time is one hour. When everything is loaded I load FspX and choose the default erj190 payload model. I
set fuel to 100% and loads the plane also to 100% with passengers and cargo.

After that I program the FMC of that plane with the FSX flightplan and start the flight. Everything goes oke and no problems during the flight.
When I end the flight I see always this:

- Flight regulations require that you have sufficient fuel reserves upon landing (45 mn); you only had reserves
for 00h22 of flight. (-300)

I don't think that's correct when I look at the fuel meter in the plane only 25-40% of the fuel is used. I don't know where to search for the
problem. Maybe is it a faulty payload model? Maybe I am doing the wrong settings? I hope someone can point me in a direction to solve
this problem.

Hope to hear from you,

Thnx

Vakantieman

[stweaver321]

Not sure what's going on. I fly the Wilco E-Jets with FSPX and don't have that problem. I would advise against using the Wilco load manager when
using FSP. Only use FSPX to load the fuel and you shouldn't have a problem.

[SkyAirWorld]

Wow you set 100% (Full mains) in a 190 for an hour flight?


You have much more than an hours worth of flying with full tanks.


As for the problem. When you load fuel use the FSP to load ther fuel.