Aeroworx Kingair 350

[snapturn]

While doing my first flight with FSPassengers, I was climbing and had a problem with pressurization so I had to lower my altitidue. It didn't matter, all the
passengers died and the report stated that I was flying at an altitude that required a pressurized plane of which I didn't have. This is wrong as the Aeroworx
Kingair 350 is pressurized. How do I fix this for future flights?

[Karl41]

This is not a problem with fspassengers. you need to pressurize your cabin, refer to your kingair manual. There is a setting in the cockpit
to pressurize, set it to auto and it does it for you. I had same problem the kingair forum is good for help too.

[Joeflyer]

Well, if you are using FsP and the payload model for this particular aircraft is not recognized as being a pressurized airplane, then it will
have the problem as described above. The thing to do is to open the payload model .ini file and make sure the box is either checked or
unchecked for pressurization.

I've got aircraft that should required setting the pressurization like the ATR-72 and Piper Cheyenne, but quickly found out that I can leave
the internal aircraft pressurization alone, as FsP takes care of it

[CDreier]

I thought Aeroworx only produced the King Air 200???

[snapturn]

Yes, you are correct.