FS Passengers adding weight.. how?

[LiamMallon]

Hi all.

I just have a quick question. I just brought the Wilco Airbus vol 2 and have got it working now with FS Passengers but was wondering how
exactly does FS Passengers add the weight, and when I have finnished my flight, how does it take it off?

Does it permanently change my aircraft config or FDE, or is it all just temporary until I end an FS Passengers flight. I am just asking as
although not bad by any means, the aircraft does handle differently. What I mean is does it write to my aircraft config/fde and make
changes or not?

Cheers,

Liam.

[Drew]

No changes to the weights in the aircraft.cfg are made.

Ive read how it works before, but dont exactly recall, something to do with changing it in the fs9 memory.

If you dont use fsp, your plane should fly exactly how it did before using fsp.

[Drew]

found the answer here....
http://www.fspassengers.com/forum/showth...3#pid87893

1 - The difference between external load managers and FsP is that you configure the load manager before you start FS. This way the load
manager can write the new settings to the aircraft.cfg and when you start FS it reads the values from there. With FsP you define the payload
after you've already loaded the plane, so the values are directly written into FS memory without altering the aircraft.cfg. It's the same process
that FS uses with its own fuel & payload menu. Otherwise you would have to reload the plane after boarding.

[LiamMallon]

Thanks mate!

[LiamMallon]

Last question,

I was disabling an option and saw main loop delay 100 , what's all that about?