AbacusFS Repaint

[Tato66]

Hi guys, i just purchased Abacus Fsrepaint and it looks like a good program, However i need help adding a logo or an image to the
aircraft texure, Before i purchased it i asked this question on this forum and was told that you can copy & paste any image but i have tried
everything and no luck. Can any one please tell me step by step how to do it i will really apreciated.

Thanks

[Jetsgo]

Tato PM'd me with this question - here is the answer:

If you are copying your picture from a website, right click and press copy. To paste it, open
up the window in FS Repaint where you "draw" on the aircraft. Make sure you are there and
not on the window where you see the actual plane. Next to paste, press CTRL + V.

That should do it.

Note that FS Repaint does not use progressive alpha channels, and copy and pasting
foriegn items might dilute the realness of the aircraft. Also, if you need to resize the picture,
do it on FS Repaint, and not programs like Microsoft Paint. MS Paint takes resizes by the
pixel, I think FS Repaint resized per every two pixel, so in the end it will come out clearer.

[Tato66]

I'm sorry Ryan but i just tried and it does not work i first copy the image go back to fsrepaint edit the texture hit ctrl+v but nothing happened.
i'm getting ready to give up on this.

Thanks any way

[Tato66]

THANK YOU Ryan it works, Now another question Please and thanks a lot, I was able to put an image on the tail and it looks great
however on the other side of the tail it looks reverse how can i fix this.

Thanks

[ILikePlanes]

THANK YOU Ryan it works, Now another question Please and thanks a lot, I was able to put an image on the tail and it looks great
however on the other side of the tail it looks reverse how can i fix this

I had this same problem

[Jetsgo]

Tato -

At the top (on the window where you "draw on the planes" you will see a bar that says "IMAGE"
Click this, and click Flip Image: Vertically, Horazontally. This should solve your problem.