70.000 km/hr - 37796 knots/hr penalty !

[Andre]

Just re-installed FSP due to new system, made some testflight with 747 400.

Flightresult: Passengers happy, in time arrival, no problems at all, etc. nice bonus.

And then some extreme penalty ! Because I did fly under 10.000 ft with a speed of 37796 knots/hr ( 70.000 km/hr )
Never exceeded 230 kts.
Never ever seen this before . Maybe re-install FSP again?

[Joeflyer]

You sure you didn't have time compression enabled?? Test with another flight and make sure time compression is not used. Never heard of this before if
using actual time. This would be a new one...EVER.

[Andre]

Joeflyer wrote:
You sure you didn't have time compression enabled?? Test with another flight and make sure time compression is not used. Never heard of this before if
using actual time. This would be a new one...EVER.

You mean slew/ simulation rate? no I did not.
Just did the same flight eheh-eham now all ok, was a little in a hurry so forgive me bad landing
http://www.fspassengers.com/?action=va&l...ght=682370

I think I re-install fsp because I've seen other probs also, like axes and other things : elevator suddenly reverse etc. not funny.



Post Edited ( 08-27-15 23:56 )

[Joeflyer]

We all have gone through the hard landings before

Changes in control axis are not due to FsP, I assure you of this.

[Andre]

Joeflyer wrote:
We all have gone through the hard landings before

Changes in control axis are not due to FsP, I assure you of this.

True

[SamTDS]

Andre wrote:

Joeflyer wrote:
We all have gone through the hard landings before

Changes in control axis are not due to FsP, I assure you of this.

True

It could be doing your controls via fsuipc if you have it. If you have got fsuipc then try doing the controls via fsx/fs9 instead.

[Andre]

SamTDS wrote:

Andre wrote:

Joeflyer wrote:
We all have gone through the hard landings before

Changes in control axis are not due to FsP, I assure you of this.

True

It could be doing your controls via fsuipc if you have it. If you have got fsuipc then try doing the controls via fsx/fs9 instead.

maybe and yes, offcource all settings in fsx, atm all works fine again, did new FsP install with older version

[SamTDS]

Andre wrote:

SamTDS wrote:

Andre wrote:

Joeflyer wrote:
We all have gone through the hard landings before

Changes in control axis are not due to FsP, I assure you of this.

True

It could be doing your controls via fsuipc if you have it. If you have got fsuipc then try doing the controls via fsx/fs9 instead.

maybe and yes, offcource all settings in fsx, atm all works fine again, did new FsP install with older version

Good glad it is working again