[Solved]cant pressurize

[mllgrennman]

hi...im flying the pmdg 747 and the passengers scream and i get a pressure warning...i pressed every button i could think of
but fs passengers still
said pressure danger increasing...any help ? thanks.

[darrinward777]

Hello, The PMDG 747 has working pressurization. Here are the complete procedures for your aircraft

https://www.scribd.com/doc/2327687/15/Co...reparation

One question I have is do you get this pressure warning once above 12000 ft on your FSP mini panel display? If so do the following:

On the FSP Start screen where you set the destination, just to the right is a box called " flight & aircraft setting " click on it and a new window will pop up.
In the section " aircraft setting (permanent ) "
Scroll down to " Force enable / disable pressurization " click on the menu drop down bar to the right and select " Force enable "
FS-Passenger will then keep that setting for the aircraft.



Post Edited ( 04-25-15 07:23 )

[mllgrennman]

Good deal Darren...Yes it's after FL120...If I force enable is that a cheat? I'd like to make sure I'm doing it right as much as possible... I read
through the tutorial and it gave a thorough description of the pressurization theory but not a "what to do"

Thanks for your help...

[darrinward777]

Hello,
No it is not a cheat, The 747 is a pressurized aircraft and FSP should therefore identify it as pressurized.

Make sure after your engine start up that you turn the packs back on. Packs are turned off only at engine start up.

[Joeflyer]

Also, make sure you are using the correct payload model and the "aircraft is not pressurized" box is unchecked within the payload model. That way you
won't have to force pressurization in the aircraft setting.

[mllgrennman]

I don't see any of the options you mentioned...
please see the screenshot...



Post Edited ( 04-26-15 07:12 )

[mllgrennman]

[Joeflyer]

Yous seem to have graphics problem going on with multiple windows open....that is just a side bar
The screenshot shows you are ready to load the aircraft, so got to "Set destination" (fill that in), then "Set Flight ID"....that will give you the
options window that Darrin was advising you about earlier. When you see the different options like setting your flight ID,etc, you will also see
"Force enable/disable Pressurization". If it shows "automatic(not forced", you need to check the payload model by going to the FsP main folder, which
now resides in your Documents folder. Open the Payload model folder and click on "Payload_Editor.exe" and select this particular 747 payload model to
ensure "this aircraft isn't pressurized" box is unchecked.
Or, while you are looking at "Force enable/disable Pressurization" within FSX, you can force the pressurization anyway. Either way, you shouldn't have
the pressurization issue unless you do this correctly.

[mllgrennman]

Problem sloved.. FSP did not recognize that the PMDG door was shut...and hence could not pressurize..."Control E " took care of it...thanks for all of
your help!