Pay load at gate

[ntsbasi]

Just a quick question...When you load your a/c in FS pax, and hit "board" passengers, do you have to reset the A/C in FS? for it to change
the config file?
Thanks Jason

[LukeJGerst]

Uh, haven't tried this, however, you cannot open the Paylaod and Fuel dialog from default FS during an FSP flight, as that could lead to
cheating on the weight and fuel!

[ntsbasi]

Lets say your in the cockpit at the gate, you open FS pax, load you airplane with payload and pax weights...after it loads do you have to go
into FS and "reset" the Airplane...I hope not, I use the PMDG and It take 15-20 min setup, in other words after you load you pax and cargo,
do you have to reset the A/C?
Thanks Jason

[Gibbmusic]

As I understood it on a previous thread, you do not have to 'reset' the plane because FSP technically overrules the weight and balance
numbers that are coming from FS9. You don't have to reset the plane for the settings to take effect.

If you don't believe me, load up a light aircraft with all the weight towards the rear and see what happens.

Gibbmusic

[ntsbasi]

Thank God for that ! Thank you
Jason