[video] FSX PMDG 747

[tbird]

Hi

Long time since I've posted a video here in this forum, so I thought it was about time to do a new one.
Enjoy

http://home.lyse.net/ReidsFlyZone/FSX%20...%20747.wmv

[Captain_Smith]

Cool video! Although I reckon you coulda shown a bit more of the exterior. :p

[crowebird]

how you get AA to work right?

[tbird]

download nHancer and AA work just fine. I use nVidia 169.21 drivers
http://www.nhancer.com

[crowebird]

i am using 169.25, and still no go even with nhancer, have tried quite a few different things, and yes I deleted the FSX profile and used
nhancer to run it, tried running both programs as admin/not, etc... no luck

[Wally]

Nice vid! I like the different selection of music :D

[xhado13]

Oh yeah, nice video!
With PMDG and FSX and recording your video at the same time? You must have one heck of a rig!

[tbird]

Nope, It's a standard E6600 OC @ E6800 speed, GF 8800 GTX vid card that isn't OC at all.
One important thing is to keep the rig clean ie the rig is only for FS

Glad you all liked it!

[Joeflyer]

I can't view the vid from this pc....anti virus prog alerts me each time that the link contains a virus I kid you not.....

[fs2004josh]

I hope FSX will finally work on my new computer specs; which is listed below.

[Joeflyer]

fs2004josh wrote:
I hope FSX will finally work on my new computer specs; which is listed below.

Seems like a very good system. Will you be able to overclock your system? 3.2Ghz might do a decent job of running FSX on low settings.
For FS9 to run very smooth, I have to overclock my rig to at least 3.1Ghz(from 2.66Ghz).

The memory you have is just like the original memory I put in my rig. One stick went bad though and had to send them both back to
Corsair for replacement. I got the XMS2-PC6400C4DHX sticks prior to the others going bad. They seem to overclock much better than the
other ones. The extruding aluminum heat sinks on the new ram takes up alot of room though.

[fs2004josh]

O yea, that cooling system kit should overlock my 3.2 ghz.