19-04-2011, 04:04 PM
After performing several test flights with with my small fleet (2 fixed, 1 rotary) I have discovered that no matter where on the runway that I
set the brake using my helicoptor I get the wrong airport penalty. These flights were to a known local airport, using the correct indentifier,
landing and setting the parking brake on the dead center of the runway. If this was an AFCAD problem then it seems that I would get
dinged using the Cessnas as well as my Schweiser. I'm at a loss here. Is there something in the .cfg that needs adjusting?



Post Edited ( 04-19-11 17:04 )
set the brake using my helicoptor I get the wrong airport penalty. These flights were to a known local airport, using the correct indentifier,
landing and setting the parking brake on the dead center of the runway. If this was an AFCAD problem then it seems that I would get
dinged using the Cessnas as well as my Schweiser. I'm at a loss here. Is there something in the .cfg that needs adjusting?



Post Edited ( 04-19-11 17:04 )
![[Image: sdc20.jpg]](http://www.fspassengers.com/images/banner/sig/sdc20.jpg)
If it's stupid, but it works, it isn't stupid.