Here we go again

[CDR]

I installed a new Beriev BE-20 aircraft.
Did a test flight with some passengers aboard.
Be fore I want to F'S Passenger I went to aircraft fuel section to check it.
There it told me I was over weight so I changed my load by putting only 25% fuel in each of the main tanks.
Once you start up the FSP you can no longer go back to fuel check as the program will not let you;
I took my test flight and every thing was good except the fowling,
-------------------------------------------
-You exceeded the maximum take-off weight of your aircraft by 1169 lbs and this is very dangerous. (-450
---------------------------------------
Isn't there smithing on the load page that tells you if you are over loaded. ?
Being a young 80 year old man im really not a grump.
I do love this program very much but some time things here are very aggravating to me.
CDR

[RonMac]

OK look at add on programs supplied with Passengers.

There is a load manager thing that allows you to customise to some extent load issues. This will tell you when you are in trouble!

At a young 80 you are to be congratulated, I am approaching or reached senior status, and cannot remember my name!

Still, this is what forums like this and Avsim are around for...us oldies can collectively help each other out.

reagrds,


Cant recall...whats my name again?

[MattNW]

I'm not familiar with that aircraft but I ran into a similar problem with the ATR. First make sure any payload editing program for the airplane
is set to empty if it uses one. FSP can't tell if an airplane has been loaded with any other program. That's what was happening with the
ATR. I had set a load in the ATR payload configurator and that plus the fuel and passengers from FSP overloaded me. Hope this helps.