14-05-2018, 02:41 AM
Hello,
I had a couple questions about the flaps penalty, as I would rather work with it than turn it off.
Thanks!
I had a couple questions about the flaps penalty, as I would rather work with it than turn it off.
- On some short runways, I sometimes need to set full flaps. Will I get penalized on certain models for this?
- Are there models that will result in a penalty, if you do not set more than one notch of flaps? The documentation seems to say that one is enough. If so, where do I check this requirement for each model?
- The docs say that you need to go up 200 ft before retracting flaps. Has anyone experience problems with this, when the airport itself was at a very high altitude?
Thanks!