31-08-2016, 10:32 PM
Hello everyone
After 9 months without a flight I finally returned to P3D and flying (virtually)
I decided to do a short international flight from LCLK to LGIR. During approach there was a problem with the gear. None of the landing gear had been extended and decided to do a go around to see if I find a solution. Nothing changed and decided to complete an emergency belly landing. I touched the ground with a -122 ft/minute and a speed of about 122 (good enough I believe for the A321).
Right after touchdown P3D detected it as a crash and didnt let me to disembark passengers or continue the emergency.
Is there any way to make P3D allow the belly landings and dont detect them as a crash?
If not is there a way to to remove the belly landing emergency? (I dont prefer this solution)
After 9 months without a flight I finally returned to P3D and flying (virtually)
I decided to do a short international flight from LCLK to LGIR. During approach there was a problem with the gear. None of the landing gear had been extended and decided to do a go around to see if I find a solution. Nothing changed and decided to complete an emergency belly landing. I touched the ground with a -122 ft/minute and a speed of about 122 (good enough I believe for the A321).
Right after touchdown P3D detected it as a crash and didnt let me to disembark passengers or continue the emergency.
Is there any way to make P3D allow the belly landings and dont detect them as a crash?
If not is there a way to to remove the belly landing emergency? (I dont prefer this solution)
C9 pilot AK47