24-08-2016, 08:11 AM
Hi,
When I use FSP with Wilco 737 PiC I have a problem lifting the plane off the ground.
I program the FMC and load the aircraft with the sufficient amount of fuel and set the stab trim to what is stated in the FMC.
I load FSP (a variety of loads, full, not full, etc, etc) and then reset the stab trim which changes in the FMC after FSP loaded.
When I roll down the runway and reach rotation speed, when I pull back nothing happens, nearing the end of the runway the plane starts to climb.
What am I missing in the set up?
Cheers
Dene
When I use FSP with Wilco 737 PiC I have a problem lifting the plane off the ground.
I program the FMC and load the aircraft with the sufficient amount of fuel and set the stab trim to what is stated in the FMC.
I load FSP (a variety of loads, full, not full, etc, etc) and then reset the stab trim which changes in the FMC after FSP loaded.
When I roll down the runway and reach rotation speed, when I pull back nothing happens, nearing the end of the runway the plane starts to climb.
What am I missing in the set up?
Cheers
Dene